HVAC Replacement Cost in Palm Bay, FL (2026 Price Guide)

Your AC is on its last legs. It's a 1990s block house, it's the second or third system the place has had, and the repair guy just used the word "compressor" in a tone you did not enjoy. Welcome. In Palm Bay, AC is not optional, so the question is what a fair price looks like.

The short answer: a straight 3-ton replacement in Palm Bay runs about $8,000 to $10,000 for cooling-only AC, and about $9,500 to $12,500 for a heat pump. That means a matched outdoor unit and air handler, permit, old unit hauled off, and your existing ducts reused, on a typical 1,800 sq ft single-story house. The whole local market, 3 to 4 tons, runs roughly $8,000 to $13,000. Add duct work and you can land above that.

Same math applies if a storm took out the condenser, your insurer wants an old system gone before renewal, or you're buying or selling and the inspection flagged the unit. The reasons differ. The price doesn't care.

For example, based on our estimate engine, replacing a 13-year-old 3-ton system in a 1,800 sq ft Palm Bay block house with a new heat pump, garage-closet air handler and existing attic ducts reused, runs about $7,500 to $13,000.

Why Palm Bay quotes land where they do

There is no official price list for HVAC in Palm Bay, so the numbers above come from where Brevard County contractors' 2026 pricing pages overlap. One Brevard guide puts a 3-ton standard AC at $8,000 to $9,200 and a 3.5-ton at $8,200 to $9,400, with permit, line set and old-unit removal included. A Melbourne contractor and a Cocoa one both describe $8,000 to $13,000 as the typical 3 to 4 ton range. A 4-ton cooling-only system, for a house up to roughly 2,400 sq ft, runs about $9,400 to $11,000.

You will see lower numbers online. One page that mentions Palm Bay by name shows $3,300 to $8,700, but it rests on 2022 research and that world is gone. A quote of $5,000 or $6,000 for a full matched system in 2026 is usually a partial scope (no line set, no permit, no haul-away) or the cheap end of the market. One Brevard guide puts the typical gap between the cheapest quote and a legitimate one at $2,200 to $4,400. Treat a very low number as a question, not a deal.

Why not lower? Equipment keeps getting more expensive. Carrier raised residential prices about 6% in March 2025, and Goodman, Amana and Daikin went up to 8 to 10% a month later. Trane announced two increases of up to 5% each in 2026. The new refrigerant generation was expected to cost more again, with one manufacturer projecting over 10% on equipment. How much of that lands in your quote varies, but the direction is one way.

Labor is not the culprit. Metro-area wages for installation and repair workers run about 10% below the national average, per federal wage data. Contractors typically put labor at 30 to 50% of an install, and that share shrinks as the box itself gets pricier. When a Palm Bay quote is high, look at the equipment line first.

Heat pump or AC with heat strips

Most Palm Bay homes have no gas. The "furnace" in your garage closet is an electric air handler with heat strips, and a replacement means picking between two setups: cooling-only AC with strips for heat, or a heat pump that does both.

Both are legal for a straight swap. The 2023 Florida energy code added a rule against electric resistance as the primary heat for complete central equipment replacements, and a lot of articles repeat it as if it applies to everyone. A Building Officials Association of Florida interpretation says it doesn't: the rule reaches renovations over 30% of assessed value, changes of occupancy and newly conditioned space, not a routine equipment change-out. If someone tells you code forces you into a heat pump, ask them to point to the section.

So it's a money decision. The heat pump premium runs roughly $3,000 to $4,000 on one Brevard contractor's pricing, and the range gap above ($9,500 to $12,500 versus $8,000 to $10,000) says the same. What do you get for it? Winters here are mild. Melbourne's average January low is about 51.7 F, so heat strips run on relatively few nights. A heat pump heats more cheaply on those nights, but with FPL's all-in residential rate around 12 cents per kWh (October 2026 tariff), the payback is not fast. Pick a heat pump because you want it, or because the quote difference is small. Pick AC with strips if the budget is the thing and your winters are what they are.

Equipment tiers, and who should skip them

Single-stage. The standard choice. In the 3-ton range it's the $8,000 to $9,200 AC, or the lower half of the heat pump range. Contractor pages commonly cite 10 to 15 years of life. Where it's the wrong choice: a house where the unit is oversized and humidity is the complaint. A single-stage unit that blasts on and off never runs long enough to pull moisture out of Florida air.

Two-stage or variable-speed. Adds roughly $1,200 to $2,100 at 3 tons ($9,200 to $11,300 total). It runs longer at lower speeds, which handles humidity and temperature swings better. Worth it if you have clammy rooms, a sunny upstairs bedroom or a big complaint about cold-then-sticky. Skip it if the system is correctly sized and the budget is tight, because correct sizing does most of the work.

Coastal-rated or heavy-coated. Premium 3-ton systems run $11,300 to $14,300. Carrier says salt can travel about two miles inland and sells coastal models with a longer parts warranty for seacoast corrosion. Trane's coil warranty excludes corrosion from salt air outright. This matters for barrier-island and lagoon-edge lots. For most of inland Palm Bay it is money spent on a problem you don't have. Ask your contractor how close you are and what the warranty says about corrosive atmosphere before paying for it.

Sizing matters more than any of these tiers. Ask whether the contractor did a load calculation (called Manual J) or just matched the old unit. If the new unit isn't an exact-size swap, the city requires that analysis and an AHRI data sheet for the permit anyway, per its mechanical permit requirements.

Ducts, the line item that moves the quote

Most 1990s Palm Bay homes have flex duct in the attic, now 25 to 30 years old. Sun and heat make it brittle, it sags, it gets crushed under stored boxes, and it leaks. Replacing or repairing the duct system, plenum and returns typically adds $1,000 to $5,000 to a job. That figure comes from a Pinellas County contractor, so treat it as direction for Brevard, not a quote.

A good contractor looks in the attic before quoting and tells you what they see. A new system on leaky, undersized ducts is a nice outdoor unit wired to an old problem, and you will still have the same hot back bedroom. If the quote says "reuse existing ducts," ask what condition they're in, and whether they'll seal the connections at the air handler. Ask for the duct work as a separate line, so you can compare.

Attic air handlers have their own extras: a secondary drain pan and float switch so a clogged condensate line doesn't come through your ceiling, plus a proper platform and access. Garage-closet handlers are easier and usually cheaper.

Permits, rebates and credits

Permit. The City of Palm Bay requires a permit for an A/C change-out, applied for through its building permits office and e-portal. Working without one can bring a penalty of up to four times the fees, and it can complicate a home sale. The cost is small. On the city's fee schedule, the building permit formula works out to roughly $160 for a $10,000 job once admin, plan review and surcharges are added. Contractors usually pass the permit through at $100 to $500. A line that says "$800 permit fee" deserves a question.

Notice of Commencement. Florida law exempts a direct contract to repair or replace an existing heating or air-conditioning system under $15,000 from the notice-of-commencement requirement. Some older city checklists still mention a $7,500 threshold. For most Palm Bay change-outs, you shouldn't need to record one.

FPL rebate. FPL offers $200 as an instant credit on a qualifying new central AC (indoor and outdoor), and only through an FPL participating contractor. The efficiency bar is around 15.2 SEER2 or higher; check the program standards. It's about 2% of the job. Nice, not a reason to pick one quote over another. Some contractor pages quote bigger rebate numbers, but FPL's own pages say $200.

Federal tax credit. Gone. The IRS says the 25C credit won't be allowed for property placed in service after December 31, 2025. Plenty of 2025 articles still promise up to $2,000 back. Not for a job you do now.

Insurance inspections and other deadlines

The reason a lot of Palm Bay owners replace a system that technically still works: paperwork. Homes more than 20 years old need a 4-point inspection for coverage with Citizens, and the inspector reports the age, type and condition of the heating and cooling system. Median build year here is around 1993, so that covers most of the city. An older unit can hold up a renewal. A sale can do the same.

If that's you, say so when you call. A contractor can time the work around a renewal date, and the permit's final inspection gives you a record to hand to the insurer or buyer. Whether a new system lowers your premium depends on your insurer, so ask them before assuming.

Seasonally, May through October is crunch time, with heat and storm season. A quiet-month install in winter can be easier to schedule. If your system dies in July, nobody is going to hand you a discount.

Mini splits and gas furnaces

Mini splits (ductless) make sense for a garage conversion, a Florida room, an addition, or anywhere ducts can't reach. One Brevard contractor puts a single zone at roughly $3,000 to $7,000. Past about three zones the total starts to look like a central system, and the central system is usually the better buy for a whole house. Palm Bay's checklist adds work here: a mini split needs both a mechanical and an electrical permit, and the city asks for a boundary survey showing the unit's location.

Gas furnaces barely exist in Palm Bay. FPL-served slab homes mean the air handler with heat strips is what "furnace" means here. If a quote lists a gas furnace, ask where the gas comes from.

What to ask and what to watch for in a quote

Ask:

  • Is it a full matched system? Condenser and air handler/coil together. A condenser-only swap on a 13-year-old coil is a gamble, and it can void warranties.
  • What's in the price? Permit, line set, pad, thermostat, haul-away, refrigerant recovery, disconnect and whip, and condensate safety switch. Quotes that skip these look cheap until they don't.
  • What are the brand, model and SEER2? Ask for it in writing, and whether it qualifies for the FPL rebate.
  • Was sizing calculated or copied? A load calculation is the right answer. "That's what was there" is the lazy one.
  • What condition are the ducts in? Ask them to show you, and get any repairs priced separately.
  • Who pulls the permit, and are they state-licensed? The city requires state-certified or registered contractors with workers' comp and liability proof. Check the license on the state board's site before you sign.
  • What do the warranties cover? Parts, compressor and labor are different clocks. Ask who handles a labor claim in year three.

Watch for:

  • A quote far below the others. $5,500 for a full system in 2026 usually means something is missing.
  • No permit. "We can skip the permit and save you money" saves you about $160 and costs you the legal paper trail. Unpermitted work can bring that four-times penalty and trouble at sale.
  • Pressure to sign today, or a "price good for 24 hours" deal.
  • A big deposit up front. Ask what the payment schedule is tied to.
  • Quotes that won't say the model number. The model decides the rebate, the warranty and whether it matches your coil.
  • Nobody went in the attic. A price given over the phone is a guess.

Get at least two quotes with the same scope, and compare line by line. The point isn't the lowest number. It's the best work for the money, the system you won't pay for twice.

Get your estimate

Want a number for your own house? Describe the job in the box below, add a photo of your outdoor unit or air handler if you have one, and you'll get a free estimate in 2-3 minutes. If it looks right, we'll find you a vetted local HVAC contractor for the work.

Common questions

How much does it cost to replace an AC in Palm Bay?

About $8,000 to $10,000 for a standard 3-ton cooling-only system with permit and haul-away included, and about $9,500 to $12,500 for a 3-ton heat pump. Larger homes, variable-speed equipment and duct repair push the total toward $13,000 or higher.

Do I need a permit to replace my AC in Palm Bay?

Yes. The city lists A/C change-outs as work that needs a permit, and a licensed contractor normally pulls it. The city fee is typically a couple hundred dollars at most. Skipping it can bring a penalty of up to four times the fees and trouble when you sell.

Is a heat pump required in Florida now?

Not for a routine replacement. State interpretation says the energy code's electric-heat rule applies to major renovations, changes of occupancy and newly conditioned space, not a like-for-like equipment swap. A heat pump is a choice, and mostly an economic one.

Can I still get a federal tax credit for a new heat pump?

No. The 25C credit ended for equipment placed in service after December 31, 2025. FPL's rebate is separate, currently $200, and requires an FPL participating contractor and qualifying efficiency.

How long does a replacement take?

A straight same-location swap is typically a one-day job. Duct work or moving the air handler can add a few days, and permit review is the usual source of waiting, so ask your contractor how long the city is taking right now.

Get the number for your own job

A typical job is a starting point, not your job. Describe yours (a photo helps) and the same estimate engine prices it for Palm Bay in 2-3 minutes. Free, and nobody gets your number.

Sources (22)

Researched for Palm Bay, FL · Updated November 10, 2026 · Reviewed by Ralph Cockburn on November 16, 2026 · How these guides are made

Prices are researched local ranges, not quotes. The contractor who sees your job sets your actual price. More Palm Bay cost guides