HVAC Replacement Cost in O'Fallon, MO (2026 Guide)
Short answer: replacing a gas furnace and central AC together in a typical O'Fallon house runs roughly $9,500 to $15,000 in 2026. That is a matched system, installed, with permit and thermostat. Just the AC is roughly $5,500 to $9,000. Just the furnace is roughly $3,500 to $7,000. Add ductwork or electrical work and the total climbs.
You are probably here because the builder-grade system that came with your 2000-ish two-story is 20-plus years old and has started making noises, or stopped. O'Fallon is full of those houses. The same guide works if a storm took out your condenser, a compressor died young, or an inspector flagged the system while you're buying or selling. The price drivers are the same.
What you are actually pricing
Most O'Fallon jobs fall into one of five buckets. These are working ranges for a 2,000 to 3,000 square foot ducted house, installed, permit included, and they are meant to show you where a sane quote lives, not to replace a real one.
| Job | Roughly | |---|---| | Matched gas furnace and AC (the common one) | $9,500 to $15,000 | | AC only, about 3 ton, with matching coil | $5,500 to $9,000 | | Gas furnace only, 80% or 96% | $3,500 to $7,000 | | Dual-fuel: ducted heat pump plus gas furnace | $12,000 to $18,500 | | Single-zone ductless mini split | $4,500 to $8,500 |
For example, based on our estimate engine, replacing the original furnace and AC on a 2002 two-story of about 2,400 square feet with a basement (about 3 tons, both 24 years old, swapped for a 96% furnace and a 15+ SEER2 AC, existing ducts kept) runs about $8,500 to $15,500.
Why does the matched swap sit where it does? The equipment is most of the bill, labor is a day or two, and the spread between the low and high end is mostly equipment tier, whether the ducts need help, and how much the contractor charges for the same work. A basement furnace and a condenser on a pad beside the house is the easy version of this job. Nobody has to crawl through an attic.
One more thing about AC-only or furnace-only. If your two units are different ages, replacing one is legitimate. But a new AC generally needs a matching new coil, and a 24-year-old furnace sitting next to a new condenser is a countdown clock. Ask for both prices. Sometimes the matched swap costs less than twice the single price, and you only pay for mobilization once.
Why 2026 quotes run higher than the article you read in 2024
If a guide from a couple years ago said a 3-ton system costs $4,500 to $5,500, close the tab. Equipment got more expensive in a hurry. In 2025, manufacturers announced price increases of roughly 6% (Carrier) to 8-10% (Goodman, Amana, Daikin), and at least one major brand reportedly raised prices again in 2026. Part of that is tariffs and metals. Part is the switch to new A2L refrigerants (R-454B), which meant redesigned coils, condensers and safety features. The aftermarket supply of that refrigerant was tight through 2025 and has been described as settling since.
You will not see that as a line item. You see it as a number that is noticeably higher than the last time your neighbor replaced a system. It is not your contractor padding the quote.
The rebates you read about are mostly gone
This is where a 2025 article can cost you real money in expectation. Ameren Missouri's incentives moved to the PAYS program in 2025: roughly $1,000 for a central AC, $2,000 for a ducted heat pump, $250 for a smart thermostat, per the 2025 chart. That chart expired at the end of 2025. Ameren's HVAC PAYS page currently says enrollment is closed and the program is fully subscribed for 2026. So do not budget a rebate you cannot get. If a contractor quotes one, ask them to show you where it is on Ameren's site.
The federal heat pump tax credit (the 30%, up to $2,000 one) also ended on December 31, 2025. Installs this year do not qualify, even though plenty of websites still advertise it. Missouri's state-run efficiency rebates funded by the federal home energy program may not open until 2027 at the earliest, and a gas-heat house likely would not qualify anyway.
If you want to know about a reopening, check Ameren's page when you are ready to buy. If PAYS does come back, it is an on-bill arrangement tied to your meter, with 3% interest and a limit tied to your estimated savings. That is worth reading before you sign anything.
80% or 96% furnace
An 80% furnace is still legal to buy and install in 2026. It is also the last cycle for it: the federal rule phasing out non-condensing furnaces (under 95% AFUE) was upheld in court in November 2025, with manufacture banned after late 2028. So your next replacement, 15 to 25 years from now, will be a condensing unit whether you like it or not.
A 96% furnace costs more up front and adds two jobs: PVC venting and a condensate drain. In a basement install like most O'Fallon houses have, that is usually straightforward, since the drain can run to a floor drain or a condensate pump. It gets awkward when the furnace lives in a closet or attic with nowhere for water to go, or when the old flue chase is the only route out. Those are the cases where 80% is the right call, and a contractor who tells you so is being honest rather than cheap.
If your furnace is in the basement with a drain nearby, the 96% is the better long-term pick. Ask for both prices and look at the difference. Fuel savings on a 24-year-old furnace replaced by any new one are real, and Spire's base rates are going up, so the savings count for something.
Missouri's AC minimum is lower than the internet says
Many articles claim 14.3 SEER2 is the minimum in Missouri. For air conditioners it is not. Missouri sits in the DOE "North" region, where a split-system AC only needs 13.4 SEER2. The 14.3 number applies in the Southeast and Southwest, and to heat pumps everywhere.
What that means for you: a base-tier AC is legal here and costs less than Sun Belt guides imply. Is it the right pick? For a hot upstairs and sticky Missouri summers, a mid-tier unit with better humidity handling often earns its price, and a 15.2 SEER2 or higher is what any utility program has tended to require. But nobody is forcing you to buy the fancy one.
Heat pump or gas backup
St. Louis winters hit the single digits some nights, with a design temperature around 2 F. That is why a ducted heat pump here is nearly always paired with your gas furnace as backup (dual fuel), and why it runs the highest of the ducted options. Ameren's old rebate only applied if you kept gas as backup, and full gas-to-electric conversions got nothing.
Now the economics have shifted. With the rebate closed and the tax credit gone, you are paying full price for a heat pump system. Ameren's electric rates rose about 12% in June 2025, and the company has asked for roughly 10% more in 2027. Rising electric rates eat into heat pump savings relative to gas. For many gas-heat O'Fallon homes, the plain furnace and AC swap is the cheaper and more predictable route. A heat pump makes sense if you want a single system that does both, or if you plan to stay long enough that the cooling efficiency pays back. Ask a contractor to show you the operating cost math for your house, not a brochure.
A ductless mini split is a different animal. It makes sense for an addition, a finished basement, a bonus room or a sunroom, not for replacing whole-house ducted air. Stone or brick veneer, a long line run, or a condensate pump can all add labor.
What moves your quote up or down
Things that add money, roughly in the order they surprise people:
- Ductwork. Builder-grade flex duct from the early 2000s can be leaky or undersized. Repairs or replacement typically run $1,500 to $5,000 or more. A good contractor looks at the ducts and tells you what they see. A quote that assumes the ducts are fine without opening anything is a gamble.
- Electrical. A new heat pump or a bigger load sometimes needs a breaker, a disconnect, or in the worst case a panel upgrade, roughly $2,000 to $4,500.
- Line set. Reusing the old copper lines is common but depends on their condition and the manufacturer's rules. Some require a flush or replacement. Ask.
- Venting and drain. The 96% furnace extras above.
- Access. Attic air handlers, tight closets and long runs cost more in labor than a basement and a pad.
- Equipment tier. Single-stage versus two-stage or variable-speed. Variable-speed is nicer in humid summers and costs real money.
- Add-ons. Smart thermostat, surge protector, media filter, extended labor warranty. Some are worth it. Ask which are in the number and which you could skip.
Things that save money: a basement furnace with a floor drain nearby, a pad that can be reused, and ducts in decent shape.
Licenses, permits and who pulls them
Missouri has no statewide HVAC license, which surprises people. In O'Fallon, mechanical contractors must be examined and licensed by St. Charles County (Class A or B). Ask for the license number and check it with the county.
The permit is separate and comes from the City of O'Fallon. HVAC replacement is on the city's list of small projects that need a permit, handled through its online portal, and inspections booked there are typically completed the next day. The permit fee for a like-for-like swap is usually modest, often under $150, but check the city's fee schedule and make sure it is in your quote. The city adopts the 2015 International Mechanical Code with local amendments, which is the contractor's problem, not yours, unless they skip the permit. Then it becomes yours at resale.
A contractor who offers a lower price if you skip the permit is not saving you money. They are skipping the inspection that proves the work is right.
When to do it
Cooling failures bunch up in June through August and furnace failures in December through February. Contractors are busiest then, and your choices narrow. November is a shoulder month: schedules are looser and you have time to get two or three quotes. But heating season is here, so if your furnace is already limping, do not let it carry you into January. If it is just old, book it now and you will make the decision with a clear head.
What to ask and what to walk away from
Ask every contractor the same questions so the quotes can be lined up side by side:
- Brand, model numbers, SEER2 and AFUE for every piece of equipment, written on the quote.
- How did you size it? A load calculation (Manual J) is the right answer. "Same as the old one" is not, since many older systems are oversized.
- What is included: permit, thermostat, disposal, line set, pad, drain, venting, electrical disconnect?
- What happens if you open up the ducts and find problems? What is the price for that?
- Parts warranty and labor warranty, separately, and in writing.
- License number (St. Charles County Class A or B) and who does the install: employees or a subcontractor.
- Good, better, best options, so you can see what each step up costs.
Red flags:
- A price over the phone with no one looking at your house.
- No model numbers, only "a 3 ton, high efficiency."
- A federal tax credit for a 2026 install, or an Ameren rebate they cannot point to on Ameren's own site.
- "Sign today or the price goes up."
- No permit, or a discount for skipping it.
- Most of the money due before any work starts.
- Cannot or will not show a county license.
Get your estimate
Want a number for your own house? Describe the job in the box below, add a photo of your furnace and condenser if you have one, and you'll get a free estimate in 2-3 minutes. If it looks right, we'll find you a vetted local HVAC contractor for the work.
Common questions
How long does an HVAC replacement take?
Usually one day for an AC-only or furnace-only swap and one to two days for a full matched system. Ductwork or electrical work adds time. The permit typically takes a few days to a week, and the city says inspections booked through its portal are typically done the next day.
Should I replace the furnace and AC together?
If both are around 20 years old, usually yes. A new AC generally needs a matching coil, and pairing new equipment with a furnace that is about to die means paying for a second visit. If one unit is much younger, replacing only the other is reasonable. Ask for both prices.
Can I still buy an 80% efficiency furnace in O'Fallon?
Yes, in 2026 it is still legal to buy and install one. The federal phase-out of non-condensing furnaces was upheld in November 2025, with manufacturing banned after late 2028. It is the right pick only when venting a 96% unit would be impractical.
Do I need a permit, and does my contractor need a license?
Yes to both. HVAC replacement needs a City of O'Fallon permit, and mechanical contractors working in the city must be licensed by St. Charles County. Missouri has no state HVAC license.
Is a heat pump worth it in O'Fallon?
Usually as dual fuel, with the gas furnace kept for cold nights. With Ameren's rebate closed for 2026 and the federal credit gone, a heat pump system costs roughly $2,000 to $4,000 more than the matched furnace and AC swap before any incentives. Rising electric rates make the savings case harder, so ask for the operating cost math on your own house.
Get the number for your own job
A typical job is a starting point, not your job. Describe yours (a photo helps) and the same estimate engine prices it for O'Fallon in 2-3 minutes. Free, and nobody gets your number.
Sources (10)
- https://ofallon.mo.us/building-permits
- https://ecode360.com/27597383
- https://www.ameren.com/missouri/residential/energy-efficiency/hvac-pays
- https://www.ameren.com/-/media/missouri-site/files/energy-efficiency/mo-res-ee/ameren-2025-pays-incentive-chart.ashx
- https://www1.eere.energy.gov/buildings/appliance_standards/pdfs/2023_CAC_Standards_FAQ_10-5-2022_Final.pdf
- https://www.achrnews.com/articles/164568-hvac-price-increase-list
- https://www.achrnews.com/articles/165557-from-a2l-to-tariffs-hvacr-had-a-year
- https://dnr.mo.gov/energy/what-were-doing/inflation-reduction-act-home-energy-rebates-program
- https://homeenergybasics.com/heat-pumps/states/mo
- https://www.stlpr.org/economy-business/2026-06-30/ameren-missouri-customers-bills-could-go-up-by-13-a-month-2027
Researched for O'Fallon, MO · Updated November 10, 2026 · Reviewed by Ralph Cockburn on November 16, 2026 · How these guides are made
Prices are researched local ranges, not quotes. The contractor who sees your job sets your actual price. More O'Fallon cost guides