HVAC Replacement Cost in Murrieta, CA (2026 Guide)

The short answer

The AC quit on a 100-degree afternoon, or it's wheezing and you'd like to beat the next heat wave. Whichever it is, you have a 15 to 25 year old system in a Murrieta tract home, and you want a number. A full replacement of the AC and gas furnace together typically runs $12,000 to $18,000 for one system. If only the AC and coil are going and the furnace stays, expect roughly $8,000 to $13,000. If your two-story has a system upstairs and another downstairs and both are going, the total is closer to $22,000 to $34,000.

This guide works whatever brought you here: a system that died, one that's merely old and eating repair bills, a compressor or coil that failed, or a home inspection flagging the HVAC before a sale or purchase. The price logic is the same.

These ranges are built from the city's own permit records and a California cost study for inland homes of this age, then nudged for 2026.

What a Murrieta replacement costs, job by job

Full AC and gas furnace, one system (about 4 tons): $12,000 to $18,000. This is the mainstream job: new condenser outside, new coil and furnace inside, thermostat, new pad or line set work as needed, permit, and the required testing. Two sources land in the same neighborhood. Murrieta's own permit reports list 321 HVAC replacement permits from November 2025 through October 2026, with a median declared value of about $14,300 (half fell between $10,400 and $20,500). Those are estimates filed with the permit, not final bills, they skip anything done without a permit, and the low end is full of partial swaps, so read them as a floor. Meanwhile a Frontier Energy cost study of 4-ton systems in 1992 to 2010 homes in this climate zone puts a furnace-plus-AC change-out near $13,800, in 2023 to 2024 dollars.

For example, based on our estimate engine, replacing the AC and gas furnace together (around 4 tons) in a 2001 two-story, 2,200 square foot Murrieta home, reusing the existing ducts, with permit and energy-code testing included, runs about $11,000 to $18,500.

AC condenser and coil only, keep the furnace: $8,000 to $13,000. That's the "half system" swap. It makes sense when the furnace is under about 12 to 15 years old and healthy. It's the wrong call when the furnace is the same age as the AC. You'll pay for the same crew, the same permit and the same testing twice, and the furnace will die the following winter.

Two systems, both replaced: $22,000 to $34,000. Not quite double, because a crew on site for one job doesn't need two mobilizations, but close. More on that below.

Adding new ducts: roughly $2,500 to $7,000 more per system. That one is a rough range and swings with how much of the attic run needs replacing. It's the most likely surprise on a 20-year-old system, which brings us to the testing.

The energy-code testing behind every swap

Here's the part cost pages skip. In California, swapping an AC or ducted furnace in an existing home is an "alteration" under the Energy Code. That means a compliance form filed before the permit application, a third-party HERS rater who shows up after the install to verify the work, and a set of tests. Murrieta is generally in Climate Zone 10 (check your address against the state's lookup), and the Climate Zone 10 alterations checklist spells it out: airflow and fan efficacy checks on a new or fully replaced ducted system, refrigerant charge verification, and a duct leakage test when the job replaces 75 percent or more of the ducting. A full system replacement also requires a MERV-13 filter, and cooling line insulation has minimum thicknesses.

What that means in dollars: the rater's visit is typically a few hundred dollars, and a good contractor builds it into the quote. The city permit is small next to the equipment. The city's fee schedule lists an air conditioner and furnace replacement line, and the permit typically comes to a few hundred dollars or less, plus small state surcharges. Ask for the exact figure and make sure the quote says who pulls the permit.

The real swing is the ducts. Flex duct in a Murrieta attic spends two decades cooking at well over 100 degrees. It sags, crushes, cracks at the connections and leaks. If it can't pass, the fix is sealing, partial replacement, or new ducts, and that's where $2,500 to $7,000 per system comes from. The homeowner who says "just reuse the ducts" is often the one who gets a change order. Ask the contractor to look at the ducts in the attic before quoting, and to say in writing what happens if the leakage test fails: who pays, and what the fix costs per run.

A contractor who skips the permit and the rater can undercut everyone else by a few hundred dollars. You inherit the gap: no inspection record, trouble at resale, and equipment that may not meet code.

Two stories, two systems

A lot of 1990s and 2000s two-story homes here have one system for upstairs and one for downstairs. About 17 percent of Murrieta's declared permit values are $25,000 or higher, which fits two-system jobs, though that's an inference, not a count.

Quotes are often written per system, so check what the number covers. "$14,500" can be one system or the whole house. If both units are the same age and one has died, replacing both at once usually saves money and a second round of attic work. Upstairs furnaces in tight attics cost more labor: the old unit has to come out, the new one go in, and in summer that work is done in the early morning before the attic becomes unworkable. Don't be shocked if two systems in a hot attic price above a simple double.

Heat pump or gas furnace

Gas isn't banned. The regional air district rejected rules that would have forced zero-emission furnaces, voting 7 to 5 against them in June 2025, so you can legally put in another gas furnace in Murrieta today. The question is whether a heat pump suits you.

Dual fuel, a ducted heat pump keeping your existing furnace as backup: about $11,500 to $16,000. Cheaper than a full swap because the furnace stays. It's a sensible answer when the AC died and the furnace is still young.

A heat pump replacing both AC and furnace: about $14,000 to $19,500. The low end is a standard-efficiency unit, the high end a high-efficiency one. These ranges leave out any electrical panel work, which on some homes is nothing and on others a few thousand dollars. Ask the contractor to look at your panel before quoting.

Standard gas furnace plus AC: $12,000 to $18,000. Lowest first cost and the least surprise. It's the wrong choice if your ducts are failing and will need replacement anyway, or if you qualify for an incentive that's still open.

Higher-efficiency and variable-speed equipment cost more, and they're more sensitive to bad ducts. The efficiency tier matters less than the airflow test results. Equipment life in inland heat is typically on the short side, often 12 to 20 years for the AC, so the payback on a premium unit is a conversation, not a given.

Ductless mini splits are a different job: additions, garages, casitas. If your house already has good ducts and you want whole-home cooling, they're the wrong tool. Get a quote on that as its own job.

Rebates, mostly gone

If an online page promised you $8,000 back and a $2,000 federal credit, the page is old. California's state heat pump rebate program was fully reserved in Southern California in January 2026 and statewide by late February, with new requests going to a waitlist with no reopen date, as trade press reported. The federal heat pump credit ended for systems placed in service after 2025.

What remains is narrow. SCE's Home Performance Plus lists per-ton incentives for ducted heat pumps and ducted AC, but only for income-qualified customers in qualifying communities, with participating contractors. Ask a contractor whether you qualify before you plan around it. Otherwise, treat the sticker price as what you pay.

Prices are drifting up

The cost study above is from 2023 and 2024 data. Since then the trade press has reported tariff-driven price increases and longer lead times, and new equipment now uses the newer refrigerants. That's why the permit numbers, which are current, matter more than older study figures, and why the top of the ranges above is no accident. If a quote looks a little high against a 2023 article, it may just be 2026.

Permit filings here dip in January and run highest in April and through the summer, a pattern that's loose at best. If your system is limping but alive, asking about a winter install is reasonable. Nobody should promise you a discount for it.

What to ask and what to walk away from

Questions worth asking every contractor:

  • Is the permit included, and who pulls it? The answer should be "we do, it's in the price."
  • Is the HERS rater included? And what happens if the duct leakage test fails?
  • Did you look at the ducts and the attic? Not "can I see photos", did someone climb up there.
  • Did you run a load calculation? Tract-home systems were often oversized, and a bigger unit isn't a better one.
  • Exact equipment make, model, tonnage and efficiency, in writing. Plus the warranty terms for parts and for labor, and whether the manufacturer's warranty needs registration.
  • Is it one system or both, and is the thermostat, pad, line set and drain included?
  • Is the CSLB license active? Check it on the state license board's site.

Red flags:

  • No permit, or "we'll skip the inspection to save you money".
  • A price quoted only as a monthly payment. Financing fees are often baked in, so ask for the cash price too.
  • A quote that won't name the equipment model.
  • Pressure to sign today because "the price goes up tomorrow".
  • A big number with no line items, or a number far under everyone else's. A low number usually means something got left out: the testing, the permit, the ducts.

Get your estimate

Want a number for your own system? Describe the job in the box below, add a photo of the equipment label if you have one, and you'll get a free estimate in 2-3 minutes. If it looks right, we'll find you a vetted local HVAC contractor for the work.

Common questions

Do I need a permit to replace my AC or furnace in Murrieta?

Yes. The City of Murrieta issues a mechanical permit for a change-out, and the state energy code adds its compliance forms and verification testing. The permit is typically a few hundred dollars or less. A contractor who offers to skip it is saving themselves the work, not you the money.

How long does a replacement take?

Typically one day for a single-system swap and two for a two-system home, though attic access, ducts that need work and the HERS rater's schedule can stretch it. Expect the final inspection and rater verification to happen after the crew leaves.

Should I replace just the AC, or the whole system?

If the furnace is young and healthy, AC and coil only ($8,000 to $13,000) is sensible. If both units are around 20 years old, replacing both together usually costs less than doing it in two rounds, and the new AC will match the new furnace. Ask for both prices so you can see the actual gap.

Is the heat pump rebate still available?

The big state heat pump rebate is waitlisted with no reopen date, and the federal credit has ended. Some income-qualified SCE incentives may still be open through participating contractors. Plan on paying the full price unless a contractor confirms you qualify.

Can I still install a gas furnace in Murrieta?

Yes. The regional air district voted down the zero-emission furnace rules in 2025, so replacing gas with gas is legal in Murrieta today. A heat pump is an option, not a requirement.

Get the number for your own job

A typical job is a starting point, not your job. Describe yours (a photo helps) and the same estimate engine prices it for Murrieta in 2-3 minutes. Free, and nobody gets your number.

Sources (9)

Researched for Murrieta, CA · Updated November 9, 2026 · Reviewed by Ralph Cockburn on November 9, 2026 · How these guides are made

Prices are researched local ranges, not quotes. The contractor who sees your job sets your actual price. More Murrieta cost guides