HVAC Replacement Cost in Maple Grove, MN (2026 Guide)

Replacing the furnace and central air together in a typical Maple Grove house runs roughly $10,000 to $16,000, with most quotes landing around $12,500 to $13,500. A stripped-down version (a 92 to 95% single-stage furnace and a basic AC) can come in nearer $8,500 to $10,500. Furnace alone is about $5,500 to $8,500. AC alone is about $5,000 to $8,000.

You are probably here because the house is from the 1990s, the furnace is pushing 25 years, and the AC has started making noises like it wants to retire. Maple Grove built out hard in that era, so a lot of your neighbors are reading this too. If you came for another reason (hail or lightning took out the condenser, a home inspector flagged the age of the system, you are buying or selling), the numbers and the traps below are the same. Only the urgency changes.

For example, based on our estimate engine, replacing a failing 25-year-old 80% furnace and 3-ton AC in a 1998, 2,200 square foot two-story Maple Grove house with a 96% two-stage furnace and a matching 15 SEER2 AC, on ductwork in good shape, runs about $8,500 to $13,500.

What each version of the job costs

All of these assume a typical 2,000 to 2,400 square foot home, ducts that can be reused, and the permit folded into the contractor's price. Treat them as honest ranges, not promises.

  • Furnace and central AC together: $10,000 to $16,000. The common job. A 96% two-stage furnace plus a 3-ton, 15.2 SEER2 AC sits around the middle.
  • Furnace only: $5,500 to $8,500 for a 96% unit, PVC venting and condensate drain included. Add $500 to $2,500 if the water heater needs attention (more on that below).
  • AC only: $5,000 to $8,000 for a condenser and matched coil.
  • Dual-fuel (cold-climate heat pump plus a 96% gas furnace): $14,000 to $21,000 before rebates.
  • Single-zone mini-split: $4,000 to $7,500, for an addition, bonus room, sunroom or finished basement.

Replacing both at once is usually the better deal. One crew, one permit, one trip, and the new furnace and new coil get matched by the people who have to warranty them. Doing the furnace now and the AC "next year" tends to cost more in total.

A January furnace failure is the expensive way to do this. You get fewer choices and less time to ask questions, so if your system is old but alive, shop now and get the quotes done in a calm month.

Nobody is making you buy a 95% furnace

Plenty of pages claim Minnesota requires a 95% furnace. As far as the state's own furnace-replacement guidance goes, it does not set a 90%-plus minimum for a replacement, and the federal 95% rule is not in force yet. The Department of Energy's final rule sets 95% AFUE for new non-weatherized gas furnaces with a compliance date of December 18, 2028, and it has been tied up in petitions and court since. An 80% furnace is still legal to install today.

That does not make it the right pick. The gap in fuel cost between an 80% and a 95% furnace is roughly $300 to $400 a year at current Minnesota gas prices, which over a 15 to 20 year life is real money. A condensing furnace also qualifies for the CenterPoint rebate and an 80% unit does not. Where an 80% furnace makes sense: a tight budget with a good chimney already in place, or a house you plan to sell soon. If a contractor says the code forces 95%, ask which section. A good one will not mind the question.

The water heater line that shows up late

This is the surprise that makes people feel ambushed in the driveway. Your old 80% furnace and your water heater probably share a chimney or B-vent. A condensing furnace vents out the side wall in PVC instead, which leaves the water heater alone in a flue that was sized for two appliances. Cold, oversized, and prone to condensation and weak draft.

The installer is supposed to check that. Minneapolis's inspections guidance on chimneys and vents describes the same principle, and Minnesota's mechanical code applies statewide: the remaining appliance needs to be sized right for the flue, and a single-wall liner may have to become a B-vent. The fix is a chimney liner or a power-vent water heater, and it can add roughly $500 to $2,500.

So ask early: "Is my water heater on the same flue, and is the fix in this quote?" A good quote answers it in writing. A quote that is silent on it is not necessarily cheap. It may just be waiting to tell you later.

Rebates, and the December 31 cliff

There is real money here, but it comes from the utilities, not the government, and it is all on a 2026 clock. Your gas is CenterPoint Energy. Your electricity is most likely Xcel Energy, though some western addresses may be served by Wright-Hennepin Electric, a co-op with its own programs. Check your bill.

  • CenterPoint furnace rebates (installed in 2026, submitted by December 31, 2026): $200 for 92 to 95.9% AFUE, $400 for 96 to 96.9%, $1,000 for 97% and up. The dealer submits it, and processing takes up to 10 weeks.
  • Xcel central AC rebates, per its rebate sheet: $150 for 13.4 SEER2, $450 for 15.2 SEER2 with 12.0 EER2. Both require a "Quality Installation" by a participating contractor.
  • Xcel's gas furnace rebate does not apply to you. It is for Xcel gas customers, and Maple Grove runs on CenterPoint gas. Some rebate roundups will tell you otherwise.

For a 96% furnace and a 15.2 SEER2 AC, that adds up to about $850. A 97% furnace pushes it to about $1,450. Today is November 10, so the cliff is close: a job installed after December 31 may not qualify, and nobody can promise that 2027 programs repeat these amounts. If your equipment is on its last legs anyway, the calendar is worth knowing about. Before you sign, ask the contractor to confirm in writing that they file the rebate paperwork and that the equipment they quoted qualifies.

Two things are not coming to help. The federal 25C home-improvement credit covered only equipment placed in service before December 31, 2025. And Minnesota's HEAR/HOMES heat pump rebates (up to $8,000 for households at or below 80% of area median income) are still waiting on federal approval, and the state's HEAR page shows no applications open. Rebates cannot be retroactive, so equipment bought before launch will not be eligible. If your furnace died last night, you cannot wait for it. If your system works and your household income qualifies, it may be worth watching.

Your equipment options, honestly

Standard-efficiency furnace (80 to 92%)

The lowest price tier and legal today. It needs a good chimney or B-vent, does not qualify for CenterPoint's rebates, and costs more to run each winter. Wrong choice when the rebates and fuel savings would cover most of the price difference, or when there is no usable chimney, since then you need PVC anyway.

Condensing furnace (95 to 98%, two-stage or modulating)

The usual pick here, and 96 to 97% is the sweet spot. It vents in PVC through the side wall or roof and needs a condensate drain. In a Minnesota basement or garage, that drain can freeze, so a good installer routes it to a floor drain or adds heat tape and a neutralizer. Wrong choice mainly when the vent run through finished space is long and ugly. Otherwise, it is the default for a reason.

Central AC (13.4 to 15.2 SEER2)

Minnesota's cooling season is short, so premium 18-plus SEER2 units rarely pay for themselves. The 15.2 tier makes sense because Xcel pays $450 for it versus $150 for the basic unit. One wrinkle: new AC and heat pump equipment now uses A2L-class refrigerant under EPA's transition rule. If your old condenser died, you generally cannot just buy a new R-410A one, and a matched coil is standard. Ask whether the quote includes a new coil.

Cold-climate heat pump (dual-fuel)

This replaces the AC and works alongside a 92%-plus gas furnace, switching to the furnace at 40F or below. Rebates are real: Xcel pays $1,500 to $2,000 for a cold-climate ducted unit depending on how it classifies your account, and CenterPoint pays $400 for an existing home paired with a qualifying furnace (details). Stacked, that is roughly $2,000 to $3,800 off a $14,000 to $21,000 job.

Do not buy it expecting lower winter bills. At Minnesota gas prices, a heat pump usually does not beat a 96% furnace on fuel cost, which is exactly why the utility rebate requires the 40F switchover. Minnesota's own field assessment found retrofit paybacks typically longer than 10 years, falling to about 5 to 6 when a failed system is being replaced anyway. It is the right call when the AC is dead and you want a better cooling unit with spring and fall heating thrown in. It is the wrong call as a savings project on a working system. Also plan for a stand and snow clearance around the outdoor unit, and ask about panel capacity.

Ductless mini-split

Right for an addition, sunroom, bonus room or finished basement, where it costs $4,000 to $7,500 for one zone. Xcel pays $1,600 for a standard unit and $2,000 for a cold-climate one. Wrong choice as whole-house heat in a 2,000-plus square foot home with a duct system that already works. Line sets run through finished drywall add labor, and if you live in a townhome or an HOA, check where the condenser is allowed.

Permits and who does the work

Maple Grove requires a permit even for a same-for-same swap, and the cost is small. The city's fee schedule lists $75 for a furnace and/or central AC, plus a $1 state surcharge, so a furnace and AC swap is about $76 in city fees. A mini-split or new circuit likely adds a $75 electrical permit. A failed re-inspection is $75. Applications go through the city's online permit system, and the city permits page says the contractor applies for their own permit. A final inspection is required, and the contractor schedules it.

None of that is a reason to skip it. A quote that leaves out the permit or suggests skipping it is a red flag, and an unpermitted gas appliance is the kind of thing that turns into an insurance headache later. Straight equipment swaps typically do not need drawings, so the one-to-two-week plan review the city mentions generally applies to bigger projects.

On the work itself, expect furnace and AC in one to two days, and a heat pump with a new circuit or duct changes in two to three. Gas fitting and venting should be done by a Minnesota-licensed contractor, and Xcel's Quality Installation rebates require a participating one. If you are comparing quotes, ask who is actually doing the install, not just who is selling it.

What to ask and what to watch for in a quote

Ask every contractor:

  • Did you do a heat-loss calculation, or are you copying the old size? Minnesota's furnace guidance warns against automatic same-size replacement. A 1990s system is often oversized.
  • Is my water heater on the same flue, and is the fix included?
  • Which rebates does this equipment qualify for, and who files them? Get it in writing, with the December 31 date.
  • Is the permit included, and who schedules the inspection?
  • Is a new coil included with the AC?
  • What is the condensate and venting plan? You want to hear where the drain goes and what stops it from freezing.
  • Are ductwork changes in, out, or contingent? If your ducts need work, you want that number now.

Red flags: a single lump-sum price with no model numbers; no mention of the permit; "you need 95% by law"; pressure to sign today because a promotion ends tonight; a heat pump pitched mainly as a way to cut your gas bill; and a quote with no line for the water heater vent on a house that clearly shares a flue.

Add-ons are fine if you want them. Humidifiers, media filters and smart thermostats are common upsells in Minnesota's dry winters. Just make sure they are priced as separate lines, so you can say no to them.

Get your estimate

Want a number for your own house? Describe the job in the box below, add a photo if you have one, and you'll get a free estimate in 2-3 minutes. If it looks right, we'll find you a vetted local HVAC contractor for the work.

Common questions

Should I replace my furnace and AC together or one at a time?

Together, in most cases. One crew, one permit, and a furnace and coil that are matched and warrantied together. If one unit is clearly fine and only a few years old, replacing just the failed one is reasonable, but a 1990s pair usually fails within a few years of each other.

Is an 80% furnace still allowed in Minnesota?

Yes, today. The federal 95% rule has a compliance date of December 18, 2028 at the earliest and has been in litigation. An 80% furnace does not qualify for CenterPoint's rebates, and the fuel savings from a condensing unit are roughly $300 to $400 a year.

Will a heat pump lower my heating bills in Maple Grove?

Usually not, at current gas prices. A cold-climate heat pump with a gas furnace behind it is mostly a better cooling and shoulder-season unit, and it makes the most sense when you need to replace the AC anyway. Rebates of roughly $2,000 to $3,800 take the edge off the extra price.

Should I wait for the state's heat pump rebates?

Only if your system works and your household might qualify. The state program has no launch date, and rebates cannot be retroactive. If your furnace has failed, replace it now with the utility rebates that exist today.

Do I need a permit to replace my furnace in Maple Grove?

Yes, even for a same-for-same swap. The city charges $75 for a furnace and/or AC plus a $1 state surcharge, and your contractor should pull it and schedule the final inspection.

Get the number for your own job

A typical job is a starting point, not your job. Describe yours (a photo helps) and the same estimate engine prices it for Maple Grove in 2-3 minutes. Free, and nobody gets your number.

Sources (11)

Researched for Maple Grove, MN · Updated November 10, 2026 · Reviewed by Ralph Cockburn on November 16, 2026 · How these guides are made

Prices are researched local ranges, not quotes. The contractor who sees your job sets your actual price. More Maple Grove cost guides