HVAC Replacement Cost in Flower Mound, TX (2026)

Your air conditioner quit, or it is limping along, and the house is a 1990s or early 2000s two-story with the equipment up in the attic. That is the typical Flower Mound HVAC job, and this guide is built around it. It works just as well if you are holding a quote and wondering if it is sane, replacing a system that is simply old, dealing with storm or leak damage, or buying or selling a house with a tired unit.

The short answer: a complete AC and gas furnace swap for one system, in a typical Flower Mound house, runs about $10,000 to $15,000 in 2026. Entry-grade equipment sits near the bottom of that, a two-stage mid-grade system near the top, and 2026 price increases are pushing quotes toward the upper half. A house with two systems that replaces both lands around $18,000 to $30,000. These ranges are built from one local contractor's published tiers and a national trade range, then adjusted for this year's equipment increases.

For example, based on our estimate engine, replacing the AC and gas furnace in a 1998, 2,800 square foot two-story with a new 4-ton system at mid-range efficiency, attic equipment, one thermostat zone and the existing ductwork reused, runs about $6,000 to $12,500. That job reuses the old ducts and adds nothing else, so it sits under the range above.

Why an $8,000 quote and an $18,000 quote can be the same house

You will see that spread, and nobody is necessarily lying. One Flower Mound contractor's published tiers run from about $8,000 to $14,000 for an entry system, $12,000 to $18,000 for a two-stage system, and $16,000 to $20,000 or more for variable speed. Same house. Different equipment grade, different warranty, different list of what is included.

What is typically in a solid quote: a new disconnect and whip, a float switch on the condensate line, condensate treatment, a load calculation (Manual J) to size the system, the permit, haul-away of the old equipment and the new refrigerant. What often is not: duct sealing (that contractor includes it only in the upper two tiers) and a long labor warranty. Labor coverage in that same set of tiers runs 1, 2 or 5 years depending on the tier, and stretching it to 10 years costs about $3,500 more.

So a cheap number often means a missing line, not a better deal. Before you compare two quotes, line the items up. The one without a permit, a float switch or a load calculation is not the cheaper quote. It is a shorter one.

Ignore the national aggregator figures of $2,500 to $8,000 that show up for "AC installation in Flower Mound." Those are unit-only or stale numbers. They are not what a whole system costs this year, and they make every honest local quote look inflated.

Labor is part of this, but not in the way you might think. HVAC installers in the Dallas-Fort Worth area average about $28 an hour as employees (May 2023 data). That is the wage, not the billing rate, and installs are priced as flat packages. A single system is typically one full day, two systems two days, and an attic platform, panel work or real duct work adds about half a day.

Two systems, upstairs and down: replace together or pay twice

A lot of two-story houses here have one system for each floor, and they rarely die in the same summer. The usual story: the first one fails, you replace it, and the other follows a few years later, so you pay for a second install day, a second permit and a second round of everything.

That contractor says replacing both together typically saves $1,500 to $2,500 compared with two separate projects, and takes two full days. The math lands at roughly $18,000 to $30,000 for both, against $10,000 to $15,000 for one. It is a lot to hand over at once, which is why most people replace only the dead one.

Whichever way you go, ask for the price both ways. If the quote for "both" is close to double the quote for one, the bundle saving did not show up and you should ask why. If you replace only one, ask what the plan is for matching it later. A new system next to a 25-year-old one is fine. A new system on a duct trunk the old one shares is a conversation worth having before the install day.

Entry, two-stage or variable speed

Entry single-stage (around 15 SEER2). About $8,000 to $14,000 for a 3 to 4 ton system. It meets the legal minimum and cools the house. In an attic that reaches 145 to 155 degrees in summer and a cooling season of roughly seven months, expect the shorter end of the usual 12 to 20 year lifespan, closer to 12 to 15 years. Wrong choice if you plan to stay a decade or more, or if your house fights humidity: a single-stage unit blasts on and off and does not dehumidify as well.

Two-stage (around 18 SEER2). About $12,000 to $18,000. This is the tier that contractor says is its most popular, and for a 4-ton swap in a 25-year-old house it is the sensible middle. It runs longer, quieter cycles, handles humidity better, and in that contractor's package it comes with duct sealing, which matters more than the efficiency number in a house with old flex ducts.

Variable speed (20+ SEER2). About $16,000 to $20,000 or more. Wonderful equipment that needs good ducts with the static pressure headroom to feed it. Wrong choice if your original 25 to 30 year old flex ducts are staying: the system is only as good as the pipes it pushes air through, and you will have bought a sports car for a dirt road. If the ducts need replacing, plan on several thousand dollars more, and have that conversation before you pick the tier.

Heat pump, gas furnace or mini split

Gas is widely available in Flower Mound, so a heat pump here is a choice, not a necessity. A 3 to 4 ton heat pump with an air handler runs roughly $10,000 to $16,000, similar to or a couple thousand dollars above the same size AC and furnace. Oncor's rebate program (below) includes central heat pumps. The case against: a heat pump sits poorly with households that want gas heat during a hard freeze. If you like the idea but not the risk, ask about dual-fuel, a heat pump paired with your existing gas furnace.

A ductless mini split is a different tool. It is for the bonus room, the converted garage or the addition that the ducts never served, typically a few thousand dollars per zone. It is the wrong choice as a whole-house replacement in a ducted two-story.

Prices are still climbing into 2027

Equipment is getting more expensive, and the increases are scheduled. Carrier has announced an 8% residential price increase effective toward the end of this year's fourth quarter, citing about $800 million of cost pressure, roughly half from tariffs. Other component makers are raising prices 3% to 15% on dates through late November, according to ACHR News's tracking. The switch to the newer refrigerants is also in the mix. Whether that adds a few hundred dollars or a lot more varies by quote.

What that means for you: a quote held today may be higher in January, and contractors' quote validity windows are typically short. If your system is failing, there is a reason to move sooner. There is no reason to panic. An overpriced quote signed in a hurry costs more than a 3% increase.

Timing otherwise works the way you would guess. Summer, when it is 100 degrees and the line of broken systems is long, is the worst time to negotiate. Booking lead time is typically one to two weeks, and the install itself is a day. A system that is dying but still cooling in November is a chance to get three quotes without sweating.

The Oncor rebate, and the tax credit that is gone

Check Oncor, not CoServ. Flower Mound addresses are in the Oncor delivery area per electricrates.org, and CoServ itself says it does not currently offer efficiency rebates. A rebate site that tells you CoServ pays $500 for a heat pump is stale or wrong. Confirm your utility on your bill.

Oncor's 2026 Home Energy Efficiency program covers central AC, central heat pumps and mini splits. The catches:

  • It runs through contractors registered with Oncor, so ask whether yours is one. You cannot apply on your own.
  • Work has to be reported by December 4, 2026, or until the money runs out, which can come first.
  • The equipment needs to be 11.6 EER or better, and the program wants a photo of the old unit's condenser label before it comes out.
  • The per-tonnage figures are caps, not payouts: $3,200 for 4 tons, $3,400 for 5. Realistic payouts for a typical swap are likely hundreds of dollars, not the cap.

The federal tax credit is gone. The IRS says the 25C credit will not be allowed for property placed in service after December 31, 2025. A 2026 install gets nothing, including the old heat pump credit of up to $2,000. Texas's replacement home energy rebates are still being designed and are expected no sooner than early 2027, with income limits. A website that still advertises either one is working from old data.

Permit, license and the efficiency floor

A mechanical permit is typically required for an AC replacement, and the contractor pulls it. In Flower Mound that goes through the Town's building inspections, not Denton County. It is a small line item compared with a $10,000 job, and it should be in the quote. Inspection typically follows in two to three weeks, so ask whether your rebate paperwork or warranty registration is waiting on that final sign-off.

The installer needs a state air conditioning and refrigeration contractor license from TDLR under Texas Occupations Code 1302.251. It is valid statewide, and there is no separate Flower Mound license. Look the number up on the TDLR site before you sign. An unlicensed installer cannot realistically pull a permit, and an unpermitted install is the kind of thing that surfaces when you sell the house.

On efficiency, Texas is in the federal Southeast region, where split-system air conditioners under 45,000 Btu/h must be at least 14.3 SEER2, and 13.8 SEER2 at 45,000 Btu/h and above. A quote for something below that is not a bargain. It is not legal.

What to ask, and what to watch for in a quote

Ask for the same things from every contractor so the quotes can be compared:

  • Is a load calculation (Manual J) included? Many 25-year-old houses carry an oversized 4 or 5 ton system. A correct calculation can mean a smaller unit, a lower price and better humidity control. "We always put in a 5-ton" is not a calculation.
  • What is the exact model, tonnage and SEER2 of the outdoor unit, coil and furnace or air handler?
  • Is the permit, float switch, new disconnect and whip, and haul-away included?
  • Are the ducts being sealed, inspected or replaced? If not, why not?
  • What does the labor warranty cover, and for how long? Manufacturer parts warranties often require registration. Ask who does it.
  • Are you registered with Oncor's rebate program, and will the rebate come off my price? The deadline is December 4.
  • What is the cash price, and what is the financed price? One example: $12,000 financed at 9.99% over 120 months is about $159 a month. Ask whether financing changes the total on the quote.
  • How long is this quote good for? Given the price increases, a short window is plausible. A same-day-only price is pressure.

Red flags: a price with no model numbers, no permit line, a 50% deposit with no written scope (a deposit at booking is normal, the missing paperwork is not), an installer who cannot show a TDLR license, a quote that only exists if you sign tonight, and any tax credit promise for 2026. That credit ended last year.

Get your estimate

Want a number for your own house? Describe the job in the box below, add a photo of your unit if you have one, and you will get a free estimate in 2-3 minutes. If it looks right, we will find you a vetted local HVAC contractor for the work.

Common questions

How long does an AC and furnace replacement take in Flower Mound?

A single system is typically one full day, about 8 to 10 hours. Two systems take two days, and an attic platform, panel upgrade or real duct work adds about half a day. Booking usually takes one to two weeks, longer in a summer heat wave.

Should I replace just the failed system or both?

If your house has two systems, replacing only the dead one is cheaper today and usually costs more over time. Doing both together typically saves $1,500 to $2,500 compared with two separate projects. If the budget does not allow both, ask for a written price for the second one so you can see what you are deferring.

How long will a new system last in an attic here?

Plan on the shorter end of the usual range, roughly 12 to 15 years, because attic temperatures run extreme and the cooling season is long. Maintenance, a clean coil and a properly sized system help.

Is there a rebate or tax credit I can use right now?

Oncor's program can pay a rebate through a registered contractor, if the work is reported by December 4, 2026 and funds remain. Expect hundreds of dollars, not the cap. The federal 25C credit ended for 2026 installs, and Texas's income-based rebates are not expected until 2027.

Get the number for your own job

A typical job is a starting point, not your job. Describe yours (a photo helps) and the same estimate engine prices it for Flower Mound in 2-3 minutes. Free, and nobody gets your number.

Sources (12)

Researched for Flower Mound, TX · Updated November 9, 2026 · Reviewed by Ralph Cockburn on November 9, 2026 · How these guides are made

Prices are researched local ranges, not quotes. The contractor who sees your job sets your actual price. More Flower Mound cost guides